Rear wheel bearings finished!

Now that I have the axles out of the old outer bearings and all cleaned up, its time to prep and install the new rear wheel bearings.

Pack those bearings extremely well with grease.

From Z3

I'm sure there are better wheel bearing greases out there but this one was listed for Japanese wheel bearings and I don't know any better. :)

Sealed side goes toward the wheel studs.

From Z3

Slather the bearing surfaces on the axle with anti-seize.

From Z3

Like dis.

From Z3

Then I pressed the axle into the bearing.

From Z3

Easy.

From Z3

(NOTE: I edited out the two hours if fussing and cussing) lol

and whammy!

Grease them all up with spacers and studs.

From Z3

Then we move onto the inner bearings.

From Z3

Pressed them in with the same machine.

From Z3

I missed a pic of the grease seal under the flange but I'm sure you can picture it.

From Z3

Booyah. Repeat.

From Z3

Just need a fresh coat of ugly-b-gone!